How to cut laminate floor that is already installed step 1.
Cut laminate flooring after installed.
Plan the next rows.
The gap will be covered by the baseboard.
Place the tile on a stand or hold it steady with clamps.
Mine has a one inch offset from the guide to the bit.
You need the sliding action of a sliding miter saw to cut the full width of the plank.
Keep in mind that laminate flooring requires an expansion space of about 1 4 to keep the flooring from buckling when it swells slightly with warmth and humidity.
Moving from right to left the last piece in each row will always be cut off with the cut off piece from the left shifting down to begin the next row of flooring on the right.
Use a circular saw or a handsaw with at least 18 teeth per inch to avoid chipping it.
After a laminate flooring cutter the next best crosscutting tool for laminate flooring is a sliding miter saw capable of making 12 inch crosscuts.
2 mark the line on the laminate flooring.
Set the cut depth on a circular saw to 1 32 inch deeper than the thickness of the laminate flooring layer.
Cutting to width is required for the last board to install before an obstacle such as a wall cabinetry or fireplace.
You can use either a sliding model or a non sliding model just make sure the blade is large enough to cut the entire width of the laminate flooring in one pass.
A pencil or a permanent marker can.
The dremel should work sounds like you are running it to fast and or pushing the blade too hard.
How to cut laminate tile wear goggles a dust mask and gloves.
A miter saw is nice because all you need is a simple little mark and the saw will do the rest of the work this is the ideal tool and can cut perfect 90 degree cuts or any other angle up to 50 degrees for most saws.
Use a pencil or chalk to mark where the line you want to separate the board.
Make a small mark on the edge of the laminate so you know where to cut or use a chalk pencil to draw your measurement line across the face of the laminate.
The rows of laminate planks should have a staggered sawtooth appearance so that seams never line up in adjacent rows.
Using a 1 2 board placed against the wall or baseboard your bit should cut 1 1 2 from the wall or base.
Most laminate boards are wider than 5 inches so a standard miter saw won t work.
Use a utility knife to make long incisions instead of a saw.